GRAPHTEC CE5000-40CRP - How to Replace the Y-Relay Board

CE5000-UM-251-9370 6-18
6. DISASSEMBLY AND REASSEMBLY
6.2.7 How to Replace the Y-relay Board
How to detach the Y-relay board
(1) Detach the center cover (see Subsection 6.1.3 or 6.1.4).
(2) Detach the pen block cover (see Subsection 6.2.5).
(3) Disconnect all the cables from the Y-relay board.
To disconnect the Y-flexible cable:
Remove the wiring harness tiewrap and detach the core attached with double-sided adhesive tape to the
Y-relay board.
(4) Remove the push roller sensor flexible cable attached with double-sided adhesive tape to the Y-slider.
Y-relay board
M3L6 binding head screw
Core
Y-flexible cable
(5) Remove the two M3L6 binding head screws attaching the Y-relay board.
How to reinstall the Y-relay board
(1) Reattach the Y-relay board in the reverse order in which it was detached.