GRAPHTEC CE5000-40CRP - Page 59

CE5000-UM-251-9370 6-23
6. DISASSEMBLY AND REASSEMBLY
How to reinstall the Y-belt
(1) Shave 2 to 3 mm off both ends of the Y-belt until the wire comes out as shown below.
Y-belt
Shave 2 to 3 mm off both ends of
the Y-belt until the wire comes out.
(2) Hang the Y-belt on both sides of the pulley.
(3) Attach both ends of the Y-belt to the Y-slider so that four notches of the Y-belt fit into the Y-slider, then
attach with the Y-belt stopper plates removed in step (6) in the previous subsection.
Y-belt
Y-slider
Y-belt stopper plate
M3L6 binding head screw
(4) Attach the pen block (see Subsection 6.2.5).
(5) Reattach the other parts in the reverse order in which they were detached.