CE5000-UM-251-9370 6-13
6. DISASSEMBLY AND REASSEMBLY
(7) Detach the right side cam shaft holder.
Cam shaft
Cam
Right cam shaft holder
(8) Pull out the cam shaft from the right side.
(9) Detach the push roller arm spring from the push roller arm.
(10) Detach the E-ring from the push roller arm shaft.
E-ring
Push roller arm shaft
(11) Detach the push roller arm shaft from the push roller arm and detach the push roller arm, push roller arm
base, and the cam.
How to reinstall the push roller arm
(1) Spread a suitable quantity of the Shinetu silicon grease G501 on the cam as shown below.
Spread a suitable quantity of
silicon grease on this part.
(2) Reattach the push roller arm in the reverse order in which it was detached.
To Next Page
Loading...
