CE5000-UM-251-9370 7-17
7. ELECTRICAL ADJUSTMENTS
(14) Set the offset value. Press the UP ARROW key or DOWN ARROW key to change the number based on
the pen 2 cross mark.
Press the RIGHT ARROW key or LEFT ARROW key to select the X or Y direction.
(15) Verify that the plotted pen 1 cross mark line is located at the center of the plotted pen 2 cross mark line.
(16) Repeat steps (8) to (15) if the plotted cross marks are incorrectly positioned. If the plotted cross marks
are in the correct positions, press the ENTER key to store the setting and complete the adjustment.
To Next Page
Loading...
