GRAPHTEC CE5000-40CRP - Page 95

CE5000-UM-251-9370 8-5
8. SERVICE MODES
CE5000 Conditions (HP-GL Metric Eng)
Conditions Force Speed Pen Type Offset Quality
1 12 30 09U 0 2
2 14 30 09U 0 2
3 17 30 15U 0 2
4 25 10 15U 0 1
5 20 10 15U 0 1
6 20 10 15U 0 1
7 20 10 15U 0 1
8 17 10 15U 0 1
9 20 10 15U 0 1
RS-232C Baud Rate Parity Data Bit Handshake
9800 N 8 H
Command HP-GL HP-GL Origin Lower Left
Pen Up Speed Auto Step Pass 1
Offset Force
4 Offset Angle 30
Rotate Off Page Length 5000mm
Display Unit mm Sort Off
Init. Down Force 0 Auto Pre Feed Off, 1m
Expand Off
Cond. Thick Mode Overcut1 Overcut2 Dist. Adj X Y
1 Off 0.2mm 0.2mm Off 0.00% 0.00%
2 Off 0.2mm 0.2mm Off 0.00% 0.00%
3 Off 0.2mm 0.2mm Off 0.00% 0.00%
4 Off 0.2mm 0.2mm Off 0.00% 0.00%
5 Off 0.2mm 0.2mm Off 0.00% 0.00%
6 Off 0.2mm 0.2mm Off 0.00% 0.00%
7 Off 0.2mm 0.2mm Off 0.00% 0.00%
8 Off 0.2mm 0.2mm Off 0.00% 0.00%
Mark Mode Off Mark Type 1
Mark Size 20mm Mark Dist. Adj. Off
Move Position 0.0mm, 0.0mm
Mark Offset 0.0mm, 0.0mm
:,; Command Enabled W Command Pen Up
Model Emulated 7586 Cond. Priority Manual
Init Blade CTRL 2mm below
Pen Up Move Disabled HP-GL Circle Default
Media Sensor Enabled Home Sensor Enabled
Group Condition
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
Condition Factor
1 1.00
2 1.00
3 1.00
4 1.00
5 1.00
6 1.00
7 1.00
8 1.00