CS500/IS200-UM-251-9370 2-2
2. PART NAMES AND FUNCTIONS
Rear View
AC line inlet
Power switch
IEEE 1394
connector
USB
connector
Ethernet
connector
USB
connector
CS500-11 CS500-11PRO
IS200-11 IS200-11P
RO
CS500-11eN CS500-11eN-PRO
IS200-11eN IS200-11eN-PRO
CS500-11eN-A CS500-11eN-A
IS200-11eN-A IS200-11eN-PRO-A
The ab
ove illustration is of the CS500 model.
Ethernet
connector
USB
connector
Interface
selection switch
Power switch
Controls the on/off status of the power supply to the scanner.
AC line inlet
Connect the power cord’s female plug here.
USB connector
Used to connect the USB interface cable.
IEEE 1394 connector
Used to connect the IEEE 1394 interface cable.
Ethernet connector*
Used to connect the Ethernet cable.
*Please do not connect with an Ethernet connector other than an Ethernet cable.
Interface selection switch
Used to switch between USB and Ethernet (LAN) connection.
This switch is set to USB connection at the time of shipment.
Make sure that the scanner’s power supply is turned off before using the interface selection switch to select an
interface.
The USB 2.0 interface cannot be used at the same time as the IEEE 1394 or the Ethernet interface.
Do not connect
both the USB and IEEE 1394 or Ethernet cables to a computer, or to two separate computers, at the same time.
To Next Page
Loading...
