CS500/IS200-UM-251-9370 2-3
2. PART NAMES AND FUNCTIONS
POWER LED
Unlit : Is unlit while the scanner is turned off.
Lit (green) : Lights when the scanner is turned and remains lit while it is operating
normally.
Flashing (orange) : Flashes when the scanner is in power-saving mode.
PAPER LED
Unlit : Normal status (Local status).
Lit (green) : Lights when the scanner enters Scan READY status.
Flashing (green) : Flashes while image data is being scanned.
ERROR LED
Lit (red) : Lights to indicate a hardware error.
Flashing (red) : Flashes when a document is detected during the selftest when the
scanner is turned on; when scanning is suspended by pressing the
STOP key; when a paper jam is detected; or when the document
length is shorter than the specified scan length.*
Unlit : Normal status
(* When "Confirm" has been selected for the End-of-paper Processing setting in the
Scanning Master 21+ driver.)
SCAN key
This key enables you to scan a document according to the settings of Scanning Master
21+ when the scanner is connected to a computer.
Start up Scanning Master 21+ before scanning a document if it is not already active.
FORWARD key
Advances the document into the scanner. When this key is pressed in Scan READY
status, the Scan READY status is cancelled and the document is ejected toward the rear
of the scanner.
REVERSE key
Feeds the document toward you. When this key is pressed in Scan READY status, the
Scan READY status is cancelled and the document is ejected toward the front of the
scanner.
STOP key
Compulsorily stops scanning of the document.
POWER
PAPER
ERROR
SCAN
FORWARD
REVERSE
STOP
Control panel
To Next Page
Loading...
