CS510/IS210-UM-251-9370 4-4
4. INSTALLING THE SOFTWARE
4.1.2 Installing the Driver Software for Windows XP
The following procedure assumes that you are using the CS510-11eN as part of your system, and that
you are using the USB interface. The scanner name displayed in the windows is the name of the scanner
connected to the computer (CS510-11eN is used in this section).
(1) Connect the scanner to the computer, turn on the scanner first, and then turn on the computer. When
Windows starts up, insert the CD-ROM supplied with the scanner in the CD-ROM drive. Turn on the
power to the scanner.
(2) Next, the Found New Hardware Wizard window appears.
Select the option “Install from a list or specific location (Advanced)”.
(3) The screen shown below is displayed when you click Next.
Select the option “Search for the best driver in these locations” and select the check box entitled “Include
this location in the search”.
Click Browse and select the DRIVER folder in the CD-ROM drive or enter a CD-ROM drive name and
\DRIVER using the keyboard.
Example: For drive E, enter “E:\DRIVER.”
(4) When you click Next the wizard will start searching for the driver.
To Next Page
Loading...
