GRAPHTEC CS510 SERIES - 7. Jigs and Tools for Scanner Operation; Required Jigs for Scanner Adjustments; Required Tools for Maintenance; Other Necessary Items

CS510/IS210-UM-251-9370 7-1
7. LIST OF JIGS AND TOOLS
7. LIST OF JIGS AND TOOLS
7.1 Jigs
Jigs Adjustments Remarks
sc_csis4vxxx.x •Downloading system program Firmware (CS510/IS210)
OPS112 (Ver. 6.60 or later) •Downloading system program
•Shading (white correction)
•Adjusting feed distance
•Aligning sensor images
•Adjusting offset
•Color correction
Software supplied with the scanner
(Scanning Master 21+)
Calibration sheet •Shading (white correction)
•Replacing main board
Standard accessory
1050 mm x 200 mm
Color correction sheet •Color correction Standard accessory
42-inch adjustment test chart •Adjusting feed distance
•Adjusting offset
•Aligning sensor images
Record measured values between c10
and c90.
7.2 Tools
Tools Usage Remarks
Screwdriver
Allen wrench
Needle-nose pliers
Disassembly, reassembly, and other
operations
Large, medium, and small flat blade
screwdrivers and Phillips screwdrivers
Colex gauge Adjusting belt tension 200g / 4 mm displacement
Multimeter Checking voltage level
7.3 Other
Item Usage Remarks
Water-diluted neutral detergent or
absolute ethanol wiper (cloth)
Cleaning
PC
USB cable
Used to determine whether the problem
is caused by the scanner or any other
equipment.