GRAPHTEC CS510 SERIES - Drive Roller Pulley Removal and Installation

CS510/IS210-UM-251-9370 8-5
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.7 Drive Roller Pulley
Detaching the drive roller pulleys
(1) Detach the left side cover (see Section 8.2).
(2) Loosen the two M4L6 binding head screws holding the motor.
Belt
M4L6 binding
head screws
(3) Detach the drive belt from the pulleys.
(4) Loosen the M3L6WP set screw to detach the drive roller pulleys.
M3L6WP set screw
Drive roller pulley
Drive roller belt
Reattaching the drive roller pulleys
(1) Reattach the drive roller pulleys by reversing the sequence of steps in which they were detached.
(2) Adjust the belt tension (see Section 8.9).