GRAPHTEC CS510 SERIES - Replacing the Data Controller Board

CS510/IS210-UM-251-9370 9-2
9. BOARDS AND ELECTRICAL COMPONENTS
9.2 Replacing the Data Controller Board
1. Precautions for replacing the data controller board
(1) Prepare corresponded the data controller board before replacing the data controller board.
(2) Before replacing the data controller board, note the feed correction value, X overlap and Y offset values
currently selected for the scanner, if these values can be checked. (To check these values, follow the
procedure given in "Preparations before Making Adjustments" in Section 10.2.)
(3) Use Scanning Master 21+ to make adjustments.
2. Replacing the data controller board
(1) Before replacing the data controller board, note the feed correction value, X overlap and Y offset values
currently selected for the scanner, if these values can be checked. (To check these values, follow the
steps given in "Preparations before Making Adjustments" in Section 10.2.)
(2) Detach the data controller board (See "Data Controller Board" in Section 8.20).
(3) Write down the MAC address that is shown on the old data controller board on the new data controller
board.
(4) Attach the new data controller board by reversing the sequence of steps in which the old board was
removed.
(5) Set the DIP No.5 and 6 switches to ON on the data controller board.
(6) Initialize all adjustments by turning ON the power while pressing and holding down the STOP and SCAN
keys.
(7) Perform Calibration (white correction). (See "Calibration (white correction)" on p. 10-8.)
(8) Adjust the feed distance. (See "Feed Distance Adjustment" on p. 10-10.)
(9) Adjust the offset (origin). (See "Scanning Start Position Adjustment" on p. 10-17.)
(10) Align the sensor images (X overlap, Y offset). (See "Sensor Stitch alignment" on p. 10-13.)
(11) Perform Color correction (using a color correction sheet). (See "Color correction" on p. 10-22.)