GRAPHTEC CS510 SERIES - 8. Disassembling and Adjusting Mechanical Parts; Right Side Cover Removal and Installation; Left Side Cover Removal and Installation

CS510/IS210-UM-251-9370 8-1
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8. DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS
8.1 Right Side Cover
Detaching the right side cover
(1) Remove the three M4L6 binding head screws on the right side of the scanner unit.
(2) Detach the right side cover as shown below.
Right Side Cover
J3
M4L6 Binding
Head Screw
(3) Disconnect the J3 connector from the data power board.
Reattaching the right side cover
(1) Reattach the right side cover in the reverse order in which it was detached.
8.2 Left Side Cover
Detaching the left side cover
(1) Remove the three M4L6 binding head screws on the left side of the scanner unit.
(2) Detach the left side cover as shown below.
Left Side Cover
M4L6 Binding
Head Screw
Reattaching the left side cover
(1) Reattach the left side cover in the reverse order in which it was detached.