GRAPHTEC CS510 SERIES - Cleaning the Document Hold-Down Unit

CS510/IS210-UM-251-9370 5-2
5. DAILY MAINTENANCE
5.2 Cleaning the Document Hold-Down Unit
(1) Turn off the scanner.
(2) Open the top cover as described in Section 5.1 “Opening and Closing the Top Cover”.
(3) Wipe clean the underside of the document hold-down unit (see below) using a soft cloth that has been
soaked in water or diluted neutral detergent and thoroughly wrung out.
Latch
Latch
Document hold-down unit
The above illustration is of the CS500 model.
(4) Wipe the document hold-down unit once again using a soft, dry cloth (remove all moisture).
(5) Close the top cover as described in Section 5.1 “Opening and Closing the Top Cover”.
Take care not to get your fingers caught in the cover.
Scanning may be affected if the underside of the document hold-down unit becomes scratched or dirty. It must be
cleaned when necessary.