GRAPHTEC CS510 SERIES

To Next Page

To Previous Page

CS510/IS210-UM-251-9370 iii

DISASSEMBLING AND ADJUSTING THE MECHANICAL PARTS .................................. 8-1

8.1 Right Side Cover ..................................................................................... 8-1

8.2 Left Side Cover ....................................................................................... 8-1

8.3 Top Cover Assembly ............................................................................... 8-2

8.4 Front Guide Assembly ............................................................................. 8-2

8.5 Rear Cover .............................................................................................. 8-3

8.6 Motor .....................................................................................................8-4

8.7 Drive Roller Pulley ..................................................................................8-5

8.8 Drive Rollers ...........................................................................................8-6

8.9 Drive Belt ...............................................................................................8-8

8.10 Top Cover Sensor .................................................................................... 8-9

8.11 Front and Rear Paper Detection Sensors ............................................... 8-10

8.12 Control Panel Sheet Switch ................................................................... 8-11

8.13 Contact Glass Assembly ....................................................................... 8-12

8.14 CIS (Charge Coupled Device Imaging Sensor) Assembly ........................ 8-13

8.15 CIS (Charge Coupled Device Imaging Sensor) Board ............................. 8-15

8.16 Pinch Roller Covers .............................................................................. 8-16

8.17 Document Hold-down Rollers ................................................................ 8-18

8.18 Pinch Roller Units ................................................................................. 8-19

8.19 Ethernet Board ..................................................................................... 8-20

8.20 Data Controller Board ........................................................................... 8-21

8.21 Power Board ......................................................................................... 8-24

8.22 Switching Power Supply Board .............................................................. 8-25

9. BOARDS AND ELECTRICAL COMPONENTS ....................................9-1

9.1 Wiring Diagrams ..................................................................................... 9-1

9.2 Replacing the Data Controller Board ....................................................... 9-2

1. Precautions for replacing the data controller board .............................. 9-

2. Replacing the data controller board ..................................................... 9-2

9.3 Replacing the Ethernet Board ................................................................. 9-

9.4 Downloading Firmware ...........................................................................9-4

1. Items required to download ﬁrmware ................................................... 9-

2. Procedure ...........................................................................................9-4

GRAPHTEC CS510 SERIES - Page 5