GRAPHTEC F-Mark - Page 16

- 14 -
s
3
Press the “Cut Marker” button in the iMark software.
Then Cutting Plotter cuts small square for the calibration.
４
Peel off the small square cut by CE6000Plus from the calibration sheet so that the white
square can be see.
NOTICE
Make sure that the “Enable” in the “Die
Cutting” is not checked when performing
the calibration.
NOTICE
If the cut square can not be peeled off
well from the calibration sheet or if the
cut square cut out from the calibration
sheet, please adjust the “Cut force” in the
iMark software,
or adjust the blade length of Cutter
Plunger.
*For the how to adjust the blade length of
Cutter Plunger,refer to the Userʼs manual
of CE6000Plus.