GRAPHTEC F-Mark - Page 18

- 16 -
６
Press the “X” button on the upper left on the Calibration window to close it,
and remove the calibration sheet from the cutting plotter and finish the calibration.
110
７
After calibration is finished,perform the “Test Cut” to check the calibration of the F-Mark
is correctly.
NOTICE
 The calibration data is saved in the operation computer.
 When change the operation computer, needs calibration with changed computer.
 When USB cable connection was disconnected, needs calibration again.
 When performed calibration under the strong lighting such as spotlight, calibration
may not be performed correctly.