GRAPHTEC FC8600-60 - Page 111

FC8600-UM-251-9370 8-8
8 TROUBLESHOOTING
Error
code
Error Display Cause Verication item Solution
E03006
The data being input
exceeds the capacity
of the plotter’s
Execute coordinates
within the cutting area.
E03007
Coordinates of
command specied
out of cutting area.
Adjust the buffer size.
E03010
Other output
command was
executed while
executing an output
command.
Check the program.
E03011
An invalid byte was
received after ESC
code.
E03012
Invalid byte was
received within device
control command.
E03013
A parameter outside
of the permissible
range was specied
in the I/O related
command.
E03014
Too many parameters
in the I/O related
command.
E03015
Framing error, parity
error, or overrun error
has occurred.
Set the RS-232C
transmission condition.
E03016
Interface buffer
memory has
overowed.