GRAPHTEC MP303-04 - Page 15

1-2
Side view of plotter Rear view of plotter
(7) AC inlet ....................... Plug the AC adapter into this AC line inlet.
(8) Power switch ............... This switch controls the ON/OFF status of the plotter's power supply.
(9) RS-232C connector .... To use the RS-232C serial interface, connect your computer to the plotter via this
connector.
(10) Centronics connector .. To use the Centronics-compatible parallel interface, connect your computer to the
plotter via this connector.
(11) USB connector ............ To use the USB interface, connect your computer to the plotter via this connector.