GRAPHTEC MP303-04 - Manual Pen Selection; Selecting Pens via Control Panel

3-12
3.6 Pen Selection from the Control Panel
■ Procedure
(1) With the plotter in Ready mode, press the
MODE
key.
Press the or key until the menu below appears.
Pen No.
12345678
The currently selected Pen No. blinks, so press the or key to consecutively cycle through the Pen
Nos. until the desired Pen No. blinks. When the desired Pen No. blinks, press the
ENTER
key. The pen
carriage retrieves the selected pen.
If no Pen No. is selected, all the Pen Nos. blink.
(2) After the pen exchange operation is completed, press the
MODE
key to return to Ready mode.
X=
Y=
NOTE
When the Sort mode is set to ON, the pen cannot be manually selected. Though the currently selected Pen
No. blinks in Step (1), a Pen No. cannot be selected by using the or key.