GRAPHTEC MP303-04 - Setting Pen-Up Speed Mode; Pen-Up Speed Options

2-8
2.6 Setting the Pen-Up Speed Mode
The pen in the raised status can be moved at the maximum speed of both the X and Y axes. Thus, plotting that
includes a lot of diagonal movement takes less time.
NOTE
This function is less effective for plotting that does not include much pen-raised movement.
■ Procedure
(1) Press the
MODE
key and then press the or key to display the message below.
Setup
DipSW.
(2) Press the
ENTER
key to display the command selection menu.
FP-GL
(3) Press the or key until the Pen-up speed mode menu is displayed. In this example, the Pen-up speed
mode is currently set to NormalSp (normal speed).
NormalSp
(4) Press the or key to switch the Pen-Up speed mode between HiSpeed and NormalSp (the bit which
affects the Pen-Up speed mode setting blinks).
HiSpeed : Selects high speed mode.
NormalSp : Selects normal speed mode.
HiSpeed
(5) When the desired status is displayed, press the
ENTER
key. The prompt below appears.
Reset?
ENTorCAN
(6) If the setting is correct, press the
ENTER
key. Pressing the key resets the plotter to allow your new setting
to take effect.
To cancel the setting and return to Step (1), press the
CANCEL
key.
ReadyReady
or
X=
Y=