GRAPHTEC MP303-04 - The Control Panel

1-3
■ The Control Panel
The features of the MP303-04's control panel and LED lamps are briefly described in the following.
MP303-04 keys
(1) POSITION keys................ Move the pen carriage in the direction indicated by each key.
These keys are also used to set functions at the display.
(2)
ENTER
key .................... Completes input of the function being set.
(3)
PAUSE
key .................... Press to temporarily stop plotting and press again to resume plotting.
(4)
CANCEL
key ................. To cancel a setting shown on the display, press this key instead of the
ENTER
key.
(5)
MODE
key...................... Press to change the POSITION key modes.
(Pen carriage position mode ↔ Function mode)
(6)
CHART HOLD
key ....... Press to secure or release paper.
(7) POWER/PROMPT lamp .. Lights when the power is turned on.
Blinks to prompt you to press the
ENTER
key or to inform you that an error
has occurred.
(8) PAUSE lamp..................... Lights to indicate that plotting is temporarily suspended.
(9) CHART HOLD lamp ......... Lights to indicate that the paper is being held by electrostatic adhesion.