2-1
2. SETTING THE BASIC FUNCTIONS
This chapter describes how to set your plotter's basic functions. Procedures for setting the following functions
are provided in this chapter.
(1) Command mode
(2) Paper size
(3) Programmable resolution
(4) Pen/Vector sorting
(5) Pen speed mode
(6) Interface conditions
■ Setting
The basic functions are set using the panel keys while observing the display. The MP303-04 comes with its
basic functions set as follows.
Baud rate : 9600 bps MP303-04 display
Handshake mode : Hardwire
Data length : 8 bits
Parity : Even
Command mode : FP-GL
Paper size : ISO A3
Programmable resolution : 0.1 mm (100 µm)
Vector/Pen sorting : ON
Pen speed mode : Manual (ignore command input specifying the pen speed)
Pen-up speed mode : NormalSp
To Next Page
Loading...
