GRAPHTEC MP303-04 - Setting Pen Speed Mode; Manual vs. Program Mode for Speed

2-7
2.5 Setting the Pen Speed Mode
The pen speed mode can be set to Manual or Program mode.
Program mode: Command input specifying the pen speed will override the pen speed setting that was manually
selected at the plotter's control panel.
Manual mode : The pen speed setting that was manually selected at the control panel remains effective and
command input specifying the pen speed will be ignored.
■ Procedure
(1) Press the
MODE
key and then press the or key to display the message below.
Setup
DipSW.
(2) Press the
ENTER
key to display the command selection menu (the currently selected command mode is
displayed).
（command mode）
(3) Press the or key until the “Speed” menu is displayed. In this example, the pen speed mode is
currently set to M (Manual).
Speed M
(4) Press the or key to switch the pen speed mode between M and P (the bit which affects the pen
speed mode setting blinks).
Speed M : Selects “Manual” pen speed mode.
Speed P : Selects “Program” pen speed mode.
Speed P
(5) When the desired status is displayed, press the
ENTER
key. The prompt below appears.
Reset?
ENTorCAN
(6) If the setting is correct, press the
ENTER
key. Pressing the key resets the plotter to allow your new setting
to take effect.
To cancel the setting and return to Step (1), press the
CANCEL
key.
ReadyReady
or
X=
Y=