GRAPHTEC MP303-04 - Setting Paper Size; Paper Size Configuration

2-3
2.2 Setting the Paper Size
Set the paper size to match the plotting medium to be used.
(1) Press the
MODE
key and then press the or key to display the message below.
Setup
DipSW.
(2) Press the
ENTER
key to display the command selection menu (the currently selected command mode
appears).
（command mode）
(3) Press the or key to display the paper size menu and the currently selected paper size (in this
example, ISO A3).
ISO A3
(4) Each time the or key is pressed, the paper size setting changes in the sequence shown below (the
bits which affect the paper size setting blink).
ANSI B
ISO A4
Expand
(5) When the desired size is displayed, press the
ENTER
key. The prompt below appears.
Reset?
ENTorCAN
(6) If the setting is correct, press the
ENTER
key. Pressing the key resets the plotter to allow your new setting
to take effect.
To cancel the setting and return to Step (1), press the
CANCEL
key.
ReadyReady
or
X=
Y=