GRAPHTEC MP303-04 - Powering On and Initializing Plotter; Power Connection and Activation

1-7
1.4 Turning the Power On
(1) Check that the power switch is off (the “O” side should be down). If a pen is attached to the pen carriage,
remove the pen and return it to its position at the pen station.
(2) Plug the AC adapter into the plotter's AC inlet, then plug the other end of the cord into an electrical outlet
of the rated supply voltage.
(3) Turn on the plotter by pressing the "I" side of the power switch. The control panel's POWER lamp lights.
CAUTION
When the plotter is turned on, if the POWER lamp blinks, the plotter makes an abnormal noise, or it does
not function at all, immediately turn off the plotter and follow the instructions in section 5.3, “The Power is
Turned On But the Plotter Doesn't Operate.”