GRAPHTEC MP303-04 - Loading Plotting Paper; Paper Loading and Securing

1-9
1.5 Loading the Paper
The MP303-04 holds paper using electrostatic adhesion.
(1) Turn on the plotter.
(2) After the plotter is initialized, the pen carriage stops at the upper right corner of the writing panel and the
prompt below is displayed.
Set
Paper!
(3) Place the sheet in the desired position on the writing panel and then press the
CHART HOLD
key (the
CHART HOLD lamp lights) to hold the sheet.
(4) If any air is trapped between the paper and writing panel, force it out with the palm of your hand. This
completes paper loading.
(5) To remove the paper from the writing panel, check that plotting is completed and then press the
CHART HOLD
key (the CHART HOLD lamp goes off). After the pen carriage stops at the writing panel's
upper right corner, remove the sheet.