3-5
(3) When the desired pen type is displayed, press the
ENTER
key. The message below appears briefly.
Speed
OK!
(4) Finally, the currently selected pen type is displayed (in this case, water-based fiber-tip pens).
Pen Type
W.Fiber
(5) To return to Ready mode, press the
MODE
key.
X=
Y=
■ Setting the Pen Speed/Force for Individual Pen Nos.
This method lets you set the pen speed in a range of 1 to 70 cm/s in 1 cm/s increments for each pen number.
The pen force can be switched between H (HIGH) and L (LOW).
■ Procedure
(1) With the plotter in Ready mode (the coordinates of the current pen position are displayed), press the
MODE
key. The currently selected pen type is displayed.
Pen Type
W.Fiber
(2) To set the pen speed and pen force for individual pen numbers, press the or key until the display
below appears.
Pen Type
Manual
(3) To select the pen number, press the or key to cycle through the available choices as shown below.
Select “ALL” to set the same pen speed and pen force for all pen numbers.
ALL 1 2 3
8765
4
No.=ALL
Sp70,FoH
(4) To select the pen speed, press the or key to cycle through the available range of 1 to 70 cm/s.
706968321
No.=ALL
Sp70,FoH
To Next Page
Loading...
