GRAPHTEC MP303-04 - Page 47

3-10
■ Using the POSITION Keys
(5) Move the pen carriage to the desired position by pressing the keys.
The coordinates of the pen carriage's position are displayed while “X=” and “Y=” continue to blink.
Skip to Step (6).
X=+01000
Y=+01000
■ Direct numeric input
(5) Press the
MODE
key to permit the new origin position to be selected by numeric input of the coordinates.
Use the or key to move to the column you wish to change (the selected column blinks).
To switch between + and –, press the or key. To set a numeral, press the or key until the
desired numeral is displayed.
X=+00000
Y=+00000
X=+00300
Y=+00000
(6) When the desired origin position is displayed, press the
ENTER
key. To cancel the setting, press the
CANCEL
key instead of the
ENTER
key.
When the
ENTER
key is pressed, the message below briefly appears.
Offset
OK!
(7) When the message below appears, press the
MODE
key to return to Ready mode.
X=
Y=