3-41
Settings and Measurement
Internet Time Settings
The MT100 is equipped with a feature that allows the internal clock to be synchronized to a time
server via Ethernet.
This section allows you to make settings to use this function.
Setting items Description
(1) Internet Time Selects whether to adjust the internal clock using the time server.
Off Time server is not used. Time adjustment will not be performed.
On Time is adjusted using the time server.
(2) NTP Server Enter the domain name of the time server to be used.
(3) Time Zone Sets the time zone where MT100 is used. (Japan: +9:00)
(4) Synchronized Time Sets the time when MT100 is synchronized with the time server.
The internal clock will start synchronization upon the set time using the method selected in Adjust Mode.
(5) Adjust Mode Sets the method to synchronize the internal clock to the time server.
Step Sets the internal clock to the time server at Synchronized Time.
Slew Gradually synchronizes the internal clock to the time server.
Therefore, the internal clock will not be set instantaneously at Synchronized Time.
Amount of adjustment is approximately 43 s/day (approx. 10 ms in 20 seconds).
CAUTION
Synchronization is not conducted when the difference between the internal clock and time server
is less than 500 ms.
(6) Connection Test Conducts a test to confirm connection to the time server.
A message is displayed when a connection test is performed.
If a connection cannot be established, check all settings and perform the connection test again.
*The following message is displayed when the connection test resulted with an OK status.
①
②
③
④
⑤
⑥
To Next Page
Loading...