Page 16 of 48 S1047.mz-16-V1.0-EN
T
ransmitter switched on
AŌer connecƟŶg the transmiƩer to a USB power source, the display
switches to the display shown on the leŌ.
Tapping the leŌ “Charge” Įeld starts the charging process on a suitable
charger and tapping this Įeld again or disconnecƟng the USB cable stops the
charging.
Tapping the "USB" symbol in the upper leŌ corner returns to the original
display, which means that the mz-16 HoTT transmiƩer can also be used
"normally" during the charging process. Only the red ŇĂsh in the baƩery
symbol in the upper right corner of the display indicates that charging is sƟůl
running
W
ARNING
T
he charger should always be supervised during charge and it should be used
o
nly in rooms fitted with a smoke detector.
M
ass storage memory
If the mz-16 HoTT transmiƩer is connected to a compaƟďůe PC and the
"Mass storage" Įeld is acƟǀĂted by tapping, the memory of the transmiƩer
can be accessed from the PC. For example, to copy screenshots or model
data from the transmiƩer to the PC or soŌǁare updates to the transmiƩer.
N
ote
Even if the transmiƩer can no longer be switched on, the mass memory can
sƟůů be accessed in special cases, see under "Forced starƟŶg in the USB mode
Mass storage step-by-step" in the secƟon "Firmware update".
J
oystick
As soon as the transmiƩer is connected to a PC via the micro USB port of
the transmiƩer and "JOYSTICK" is selected by tapping, the connected PC
recognizes the transmiƩer as a joysƟck.
The standard seƫŶg suitable for the most Ňŝght simulators is 0% to 100%.
C
OM Port
Serial interface for future use
To Next Page
Loading...
Need help?
General
