Page 18 of 48 S1047.mz-16-V1.0-EN
TransmiƩer Power
Installing the BaƩery
Charge the BaƩery
BaƩery Removal
Low Voltage Warning
BaƩery use Timer
The mz-16 HoTT transmiƩer is normally delivered with a 4000 mAh 1s2p
LiPo baƩery.
N
ote
Pay aƩenƟon when inserƟŶg the baƩery to the correct posiƟon and make
sure the contacts are solid. InterrupƟons of the power supply to the
transmiƩer during the use of the models can lead to serious danger to
yourself and to other people!
Insert the connecƟon plug of the transmiƩer baƩery into the baƩery
connecƟon sockets with the correct polarity. The corresponding symbols are
engraved above the two connecƟon sockets: R
ed = + Black/Brown = -
The transmiƩer baƩery is charged by means of the micro-USB socket on the
back of the transmiƩer. Further details can be found in the secƟon
"Charging" under "micro USB socket".
Open the baƩery case cover. LiŌ the baƩery and then carefully remove the
plugs of the power cable.
You can charge the baƩery outside the transmiƩer. Consult your charger
instrucƟons for proper charging
The supply voltage of the transmiƩer must be monitored during operaƟon.
If it drops below an adjustable capacity limit which by default is 20%, an
appropriate warning message will conƟŶƵously sound.
Stop operaƟon of your transmiƩer and charge the baƩery!
A
ttention
As soon as the supply voltage of the transmiƩer falls below 3.6 V, the
transmiƩer switches oī automaƟcally without further warning.
The baƩery used Ɵme is added each Ɵme the transmiƩer is switched on.
AŌer each charge or baƩery exchange the Ɵmer is reset to "00:00".
However, this only happens if the baƩery voltage is noƟceably higher than
before. By default, the baƩery service Ɵmer as well as the model operaƟŶg
To Next Page
Loading...
Need help?
General
