Page 45 of 48 S1047.mz-16-V1.0-EN
Forced USB Update
5. As soon as the update is successfully completed, the transmiƩer
restarts.
If the forced update fails due to a missing update Įůe, then proceed as
follows:
1. Press and hold the lower two buƩons on the leŌ and right of the
display while turning on the transmiƩer.
2. As soon as the ON / OFF switch border lights up orange, press and
hold the two middle buƩons on the leŌ and right of the display.
3. When the border of the ON / OFF switch turns red, release the keys
4. Following the instrucƟons in the transmiƩer display, connect the
transmiƩer to the PC or laptop via USB cable.
As soon as the connecƟon is established, the message "USB Mass
Storage Connected" appears in white text on the transmiƩer's
display.
In the Įůe explorer of the PC or laptop appears a drive "MZ-16 (X :).
5. As described above in previous points "UpdaƟng the TransmiƩer”
load a ĮůĞ suitable for updaƟng the mz-16 HoTT transmiƩer onto the
transmiƩer.
6. Switch oī the transmiƩer and disconnect the USB cable from your
computer.
7. Do a forced update as described above.
To Next Page
Loading...
Need help?
General
