Page 27 of 48 S1047.mz-16-V1.0-EN
do is power the other airplane and wait for the receiver to establish
the bind
N
ote
You can view the associated bind group belonging to a memory model in the
"Bind" column on the right-hand edge of the "Model List" submenu.
A
ttention
If you tap on the bind group bind number ID in the “RF Set” menu the
transmiƩer will release the bind from the acƟve model memory if RF is
switched oī.
Binding a Model
1. Move the transmiƩer and receiver at a moderate distance from each
other (30cm or 1ŌͿ.
2. Switch on the mz-16 HoTT transmiƩer without switching on the RF
or set the RF Transmission to "OFF" in the "RF Set" ĮĞůd of the "RF
Set" menu.
3. Switch the receiver power system on.
4. Put the receiver in bind mode according to its manual.
5. In the transmiƩer display, touch the desired value ĮĞůd "RX1 ... RX2"
in the "Bind" column to enable the transmiƩer-side binding process.
If the bind was successful you will noƟce in the Rx column of the transmiƩer
the number of receiver channels for example R6, R12 with a highlighted blue
background and the LED on the receiver will change its color or state.
In case of an unsuccessful bind change the posiƟons of the devices and
repeat the enƟre procedure.
Removing Existing Bind
1. Switch on the mz-16 HoTT transmiƩer without switching on the RF
or set the RF Transmission to “OFF” in the “RF Set” ĮĞůd of the “RF
Set” menu.
2. In the transmiƩer display, touch the desired value ĮĞůd "RX1 ... RX2"
in the "Bind" column to trigger a transmiƩer-side binding process.
The exisƟng binding is deleted during the binding aƩempt (receiver
must be switched oī for removing the bind)
Multi Receiver Binding
The mz-16 supports mulƟ receiver binding. You can bind up to two Graupner
HoTT receivers. Each bound receiver can add to the total available channels
of all receivers bound to a single model.
For example, if the Įrst bound receiver is an 8-channel receiver and the
second bound receiver is a 6-channel receiver the total channel count is 14
channels.