Page 30 of 48 S1047.mz-16-V1.0-EN
Digital Switches
The mz-16 HoTT transmiƩer features 16 digital switches. These can be
found in the “Special” menu and can be deĮŶed, acƟǀĂted and switched in
the submenu “Digital Switch”. In addiƟon, each of these 16 Digital Switches
can be arbitrarily placed as a widget on one of the widget pages and
operated from there.
Available switching funcƟons are:
ͻ ON/OFF switching funcƟon
ͻ PulsaƟŶg switching funcƟon
ͻ Momentary switching funcƟon (0- 10 seconds)
On the receiver side, these digital switches can be assigned to the
respecƟǀely desired switching channel. Mapping a digital switch to a
receiver channel can be done in the “RF Set” menu or directly on the
receiver using the “Telemetry” SeƫŶg & Data View ASCII menu.
N
ote
This funcƟon is only available with receivers that have been updated with
the current Įrmware release.
When seƫŶg digital switches verify that only the intended receiver where
such assignment is to be made is acƟǀe. No other receiver should be acƟǀe.
Assigning Digital Switches in RF Set
1. Bind the receiver you wish to assign to a digital switch and verify no
other receiver is acƟve.
2. Switch to the submenu “RF Set” of the basic menu.
3. Select the receiver you would like to use by tapping on the blue ĮĞůd
which is the acƟve receiver.
4. By tapping the blue ĮĞůd with the receiver type a selecƟon window
appears.
5. Tap the channel number for which you would like to assign a digital
switch.
The tapped ĮĞůd is displayed inverted and a control panel is displayed
at the boƩom (see leŌ Įgure).
6. Use the “”- or “” buƩons to assign the desired Digital Switch to the
selected receiver channel.
In the illustraƟon on the leŌ, for example, the digital switch “D1” is
selected at the receiver connecƟon 4 of the receiver (the bound
receiver is a GR-16, 8 channel receiver but you can use any HoTT
To Next Page
Loading...
Need help?
General
