Page 41 of 48 S1047.mz-16-V1.0-EN
RF CommunicaƟon
WLAN OperaƟon
t R
eceiver Button
Connected telemetry sensors to the acƟǀe receiver will show on the
boƩom of the Telemetry menu display provided they were
connected prior to powering the receiver.
To access the telemetry displays of a Telemetry device, open the
"SeƫŶg & Data View” display, then tap the value Įeld labelled
"Receiver" in the lower right corner and select the desired device in
the selecƟon window that appears.
The operaƟon of these displays is the same as described above
under "funcƟon of the cross-shaped keypad".
N
ote
All seƫŶgs made via the “Telemetry” menu in the receiver, such as, fail-safe,
servo reverse, end points adjustment, mixer and curve seƫŶgs, etc. are
stored exclusively in the receiver’s seƫŶgs.
Most of these seƫŶgs can be made directly on the transmiƩer which is the
proper way for seƫŶg up your model memories. In case you chose to do
this on the receiver you must reiniƟĂůŝze the receiver when installing into
another model to avoid taking over seƫŶgs that may not work with another
model
In the WLAN and GPS menu you can establish a Wi-Fi connecƟon to your
local network or acƟǀĂte a GPS receiver if installed.
To acƟǀĂte the Wi-Fi connecƟon Įrst tap on the switch icon (right in the
WLAN tab), then tap on the WLAN icon (cloud with arrow). A list of
available networks will be displayed. Select your network and enter your
login credenƟĂůs if needed.
N
ote
The mz-16 WLAN MAC address can be found in System – Info & Update
under ID InformaƟon. THIS IS ONLY NEEDED when you use WLAN security
seƫŶgs including the MAC address.
If there is an acƟǀe connecƟon the WLAN symbol will be lit on the main
display.
To Next Page
Loading...
Need help?
General
