Page 34 of 48 S1047.mz-16-V1.0-EN
Setting a Curve
1. Tap on the “Value” menu tab.
2. Move the verƟcal green line with the control sƟck to the to the
desired point.
The selected point is displayed in red and on the right the number of
the point as well as its coordinates are shown in orange rectangles
at the lower and leŌ display edge.
3. The selected point can now be moved either horizontally or
verƟcally...
... either by tapping the symbols in increments of 0.1%.
… or by moving the respecƟve yellow rectangle horizontally or
verƟcally with a ĮngerƟp or a stylus suitable for touch screens.
Touching the icon resets the value of the selected line back to
the default value.
Adding a Curve Point
1. Use the relevant control to move the verƟcal green line between two
points.
As soon as the plus symbol is visible on the right edge of the
display, another point can be set by tapping the symbol. You can
add three more points to the exisƟng curve.
2. If necessary, adjust the posiƟon of the added point as described
above.
3. If necessary, proceed idenƟcally with further points.
Deleting a Curve Point
1. Use the relevant control to move the verƟcal green line to the point
to be deleted.
The selected point is displayed in red and the top right shows the
number of the point and the minus symbol to the right.
2. Tapping the icon deletes the selected point.
3. If necessary, proceed idenƟcally with further points
To Next Page
Loading...
Need help?
General
