Page 39 of 48 S1047.mz-16-V1.0-EN
Note
ͻ The height of the bar is a measure of the recepƟon level expressed as
logarithmic values with the unit dBm (1mW = 0dBm).
ͻ 0 dBm corresponds to the two baselines in the above
graph. Consequently, the level is poorer the higher the bar
and vice versa.
ͻ The dots above the bar mark the worst recepƟon levels
from the opening of the "RF Status" display. A reset of
these points is therefore possible by exiƟŶg and recalling
this display.
ͻ In addiƟon to the graphic display of the recepƟon level,
addiƟonal numeric informaƟon is provided to the leŌ.
This means:
Value DescripƟon
Tx ant. Quality expressed as a percentage of the signal
packages from the receiver arriving at the transmiƩer
Tx strength Quality expressed as a percentage of the signal
packages from the transmiƩer arriving at the receiver
Tx dBm Level in dBm expressed as the percentage of the
receiver signal arriving at the transmiƩer
Lost pack. Indicates the number of lost data packets
Rx ant. Quality expressed as a percentage of the signal
packages from the transmiƩer arriving at the receiver
Rx strength Quality expressed as a percentage of the signal
packages from the receiver arriving at the transmiƩer
Rx dBm Level in dBm expressed as the percentage of the
transmiƩer signal arriving at the receiver
Voltage actual operaƟŶg voltage of the power supply of the
receiving system
To Next Page
Loading...
Need help?
General
