GRAUPNER mz-32 HoTT Reference Manual

Graupner mz-32 Help Reference Manual
Page 25 of 42 Help-Ref-EN-V1.0
FREE MIXERS DETAIL
Tap on the Other menu selection to set the basic values
for the mixer.
Tapping on the Group icon will toggle the Group setting
between global and phase dependent.
Tapping on the Action icon will activate or de-activate
the mixer or assign a switch (Input Control) by tapping
on the Control field, which will activate the Select Input
Control screen.
Tap on the Curve type icon to create a mixer behavior
based on your preferences.
The default setting is linear (dual point); the channel
output increases/decreases by equal amounts over the entire range.
Tapping on the Spline icon will set a linear or nonlinear curve fitting between the individual
points on the curve.
Tap on the Value menu to make changes to curve settings.
A flat (horizontal) curve can only have its Offset / Y axes value changed.
A dual point curve can have its Offset and both Y axes (L and H) values changed. The
changes occur in reference to the zero/midpoint of the curve.
A multi-point curve permits changes for each individual point. Select a point by moving the
cursor over a point (color changes) and use the X or Y arrow keys (left, right, up, down
icon) to change the point values.
Add additional curve points by positioning the cursor line at the desired location on the
curve and press the plus (+) icon.
A selected point on an axis can also be adjusted by moving the orange marker of the
respective axis. Simply tap and hold down on the marker to move it, use the arrow keys
for fine adjustments.
To remove a curve point, select the point by moving the cursor over the point or tap on the
point (point will change color), then tap on the minus icon next to the Point number field.
Tap on the Basic menu selection to review or change the mixer settings.
Tap on the Link field to specify how the mixed channels will be linked.
 None
 Link
 After Mix
 After Mix with Trim
F14S2
DUAL MIXERS
The Dual Mixer menu provides settings for bi-direction
mixers.
It is basically a cross mixer like in a V-Tail setup. The
assigned Master channel will cause the same
directional control surface movement on the Slave
channel. However, the Slave channel will have the
opposite/reverse control surface movement on the
master channel.
Tap on the + icon in the No column to add the first
mixer.
Tap on the number in No column to activate the edit
toolbar.

GRAUPNER mz-32 HoTT Specifications

General

Brand	GRAUPNER
Model	mz-32 HoTT
Category	Transmitter
Language	English