Graupner mz-32 Help Reference Manual
Page 35 of 42 Help-Ref-EN-V1.0
TRAINER
You can use your Graupner radio for training purposes
in a Teacher/Student mode. This operation can be
done wireless with two Graupner radios or with a cable
between a Graupner radio and other transmitter
brands, using the DSC port on the back of the radio.
Tap on the Act icon to activate Trainer mode.
Tap on the Mode field to designate the function of the
radio as Teacher or Student.
Settings specific to Teacher Mode
Tap on the Ctrl field to assign a switch (Input Control)
for the teacher to take or release control from the
student.
Tap on the Ch Input field which will activate a new screen with following options:
Tap on the name in the Channel column to assign a different channel for Input.
Tap on the Control field to select which channels are released for Student control (color will
change from red to blue). You can select from a maximum of sixteen channels.
Close screen by tapping on Trainer icon, upper left corner of screen.
Tap on the Model field to select which model is bound to the appropriate transmitter.
Settings specific to Student Mode
Tap on the Ch field to assign a different channel to an Output of the transmitter.
Tap on the Connect field to set the connection mode of wireless or DSC. If wireless is
selected, you will need to bind to a Graupner radio.
Tap on the Bind field to initiate a bind to the Teacher or Student transmitter. Both
transmitters must be in bind mode for a successful binding.
Tap on the Signal Pos. to select if also programmed model memories can be used for
student operation when in Teacher mode.
S13S1
TRAINER CHANNELS
In the channel menu you can select which channels are
released for student control and which sequence.
Tap on the Channel number to change the input /
output of channels if needed.
Tap on the Control icon to enable student control for
that channel.
S13S2
To Next Page
Loading...
Need help?
General
