GRAVOGRAPH LS100 EX - Engraving Execution and Material Handling

55
M_LS100IQ EX Energy_EN_C
Using the machine
7. Start-up engraving
1. Switch on the air extraction system.
2. Activate the air extractor: Press the key.
(Control panel).
3.Checkthattheobjectiscorrectlypositionedintheengravingarea.
4. Check the focus.
5. Check that the door is closed.
6.Checkthatthescreenisdisplayingthe󰄈lename.
7. Press the key. (control panel).
8. Removing and reloading material
Thelaserbeamisshuto󰘯oncethemachinehas󰘰nishedprocessingthematerial.Theheadgoesbacktothe
origin (top left corner).
Beforeopeningthedoor,waitafewsecondsforanyremainingfumesemittedduringthemarkingorcutting
process to be removed by the extraction system. In the L-Solution driver, it is possible to enter a timeout value
tosetadelaybeforetheairextractionsystemstopswhenmarkingis󰘰nished.
Open the upper door Remove the material.
Loadthenextmaterial.Ifitisthesamematerialastheonebeforeandthesame󰘰leisbeingexecuted,close
thedoor.Start-upengraving:Pressthekey.