3
Setting up the Hardware and Software
The serial port on the Lap PC (as in Figure 2) is used to connect to the probe while
taking readings. Before attaching the probe, be sure the COM port is clear and that
the COM indicator appears in the lower right-hand side of the screen.
For most laptop PCs, you will use the mouse, touchpad or trackball to navigate in
WolfSense IAQ LAP. For the Fujitsu Lifebook, you may also use the stylus pen to tap
options on the screen. In this manual, you will see instructions to click on or tap an
option.
Complete the next 4 steps to install WolfSense IAQ LAP software.
1. Familiarize yourself with the Lap PC user manual and the Microsoft
Windows™ 98 manual.
2. Follow the instructions for setting up the Lap PC, including the manufacturer’s
recommendation for the number of hours to charge the battery pack before the
first use—even if powering it with the AC adapter provided.
3. Install the WolfSense software from the CD-ROM supplied in the kit:
If the CD doesn’t run automatically, from the PC Start menu,
run [drive]:\Setup.exe.
The Setup program loads WolfSense IAQ LAP and WolfSense PC onto your
Lap PC, and places two icons on the desktop.
4. Double-click or double-tap on the icon to start WolfSense IAQ LAP or WolfSense
PC. Use WolfSense IAQ LAP to collect readings from the probe and WolfSense
PC to analyze and manipulate stored readings.
To Next Page
Loading...