Menu Structure & Configuration
30
The light at each sensor box shows the alarm status at that sensor. Green light means no
alarm and/or warning. Yellow means active warning and red means active alarm at that
sensor. Black means the sensor is not configured or no data is yet received from the sensor.
6.2.2 Sensor Menu
If only one sensor is configured, the sensor menu will be the same as the home menu. If
two sensors are configured, pressing the sensor name (e.g. S_1) will give the access to the
sensor menu of that sensor (Figure 4-9). The sensor menu dis- plays the following infor-
mation:
• Sensor name: S_1 as default setting for sensor 1 Global alarm condition (to the right
of Setup):
• - Green light: No warning and alarm
• - Yellow light: Warning
• - Red light: Alarm
• Alarm condition of the selected sensor (to the right of the sensor name):
• - Green light: No warning and alarm
• - Yellow light: Warning
• - Red light: Alarm
• - Black: Sensor not configured or no data received. Alarm level: 2% opacity as
default setting
• Software version of the transceiver: e.g. FW 001.001
• Current opacity level: e.g. 10%. When the current opacity level is within the green area,
it means no alarm and/or warning. Yellow area means warning. Red area means alarm.
The sensor menu has also 4 functions buttons:
• Setup: to access the sensor setup menu
• Alarm: to access alarm list
• Trend: to access trend menu
• Home: to go back to the home menu
6.2.3 Alarm List Menu
By pressing Alarm on the Sensor Menu, the Alarm list menu as shown on Figure 6-10 will
appear.
To Next Page
Loading...