Introduction
Page 6 of 46
1 Introduction
1.1 About this Manual
This manual contains data and instructions for the installation, operation, and maintenance
of the G16 Smoke Density Monitor.
The instructions are given in general terms and do not take into consideration a specific
installation. As such, the instruction manual is designed for the Opacity Monitor delivered
by Green Instruments A/S.
Note that each Smoke Density Monitoring System is configured at the factory ac- cording
to specifications. Therefore, it is important to study this manual and the Technical Draw-
ings for each system in their entirety for the installation, operation and maintenance of the
system.
The manual does not describe all possible situations, but only the most common and known
situations. It cannot replace the necessary education and training of the personnel. Should
situations not described in this manual occur that cannot be solved in accordance with
normal known practice and good workmanship, the operator should contact Green Instru-
ments A/S for instructions.
This manual does not claim to cover all details or variations in equipment or to provide for
every possible contingency that may arise during installation, operation, or maintenance.
Green Instruments A/S reserves the right to minor alterations and improvements owing to
developments without being obliged to enter the corresponding changes in this manual.
Green Instruments A/S reserves the copyright of the manual. Without prior written permis-
sion of Green Instruments A/S, the manual may not be copied and given to unauthorized
people
Before operation read all instructions and warnings within this manual and associated
documentation. Improper use may cause personal injury and/or damage of equipment
and may void the warranty.
Green Instruments A/S disclaims any responsibility for damage and/or injury caused
by improper installation, use or maintenance of the equipment.
To Next Page
Loading...
Need help?
General