G16 Smoke Density Monitor
Ver.2.4 – Revision March 2022 5
Table of Figures
FIGURE 5-1: INSTALLATION OF THE G16 SMOKE DENSITY MONITOR 16
FIGURE 5-2: MOUNTING OF A SUPPORT AND ALIGNMENT BRACKET 17
FIGURE 5-3: MOUNTING OF AIR MODULE, AUDIT MODULE (OPTIONAL) AND TRANSCEIVER 18
FIGURE 5-4: MOUNTING OF AIR MODULE AND REFLECTOR 19
FIGURE 5-5: INSTALLATION OF THE CONTROL AND MONITORING UNIT 21
FIGURE 5-6: INSTALLATION OF THE JUNCTION BOX 22
FIGURE 6-1: TRANSCEIVER INTERFACE 24
FIGURE 6-2: ILLUSTRATION OF STRONG SIGNAL, NO OBSTRUCTIONS TO THE LIGHT BEAM 24
FIGURE 6-3: ILLUSTRATION OF WEAK SIGNAL, OBSTRUCTIONS TO THE LIGHT BEAM 25
FIGURE 6-4: ILLUSTRATION OF POOR AND GOOD ALIGNMENT 26
FIGURE 6-5: TRANSCEIVER ADDRESS SETTINGS 27
FIGURE 6-6: THE AUTOMATIC SPAN CALIBRATION ACTIVE AFTER ZERO CALIBRATION 28
FIGURE 6-7: AUTOMATIC SPAN CALIBRATION ACCEPTED 28
FIGURE 6-8: HOME MENU WITH 1 CONFIGURED SENSOR - SENSOR MENU 29
FIGURE 6-9: HOME MENU WITH 2 CONFIGURED SENSORS 29
FIGURE 6-10: ALARM LIST MENU 31
FIGURE 6-11: SELECT AN ALARM IN THE ALARM LIST MENU 31
FIGURE 6-12: ALARM INFO SCREEN - E.G, NOT ALIGNED ALARM 32
FIGURE 6-13: TREND MENU 34
FIGURE 6-14: PASSWORD POPUP WINDOW 35
FIGURE 6-15: SENSOR SETUP 35
FIGURE 6-16: SYSTEM SETUP 37
To Next Page
Loading...
Need help?
General