G16 Smoke Density Monitor
Ver.2.4 – Revision March 2022 35
Figure 6-14: Password Popup window
The Sensor Setup Menu has two function buttons:
• System: to access the general System Setup menu
• Home: to go back to the home menu
Figure 6-15: Sensor Setup
The light on top of the screen shows the global alarm status. Green/Yellow/Red light means
no alarm and/or warning/active warning/active alarm.
Besides, the following parameters of each sensor can be configured in its sensor menu:
Unit Name
The default names set up at the factory is S_1 and S_2. However, the name of each sensor
can be changed if it gives more meaning for the operator, e.g. S_1 can be changed to Eng_1
(i.e. sensor 1 monitors the exhaust gas from the main en- gine), S_2 to Incr (i.e. sensor 2
monitors the exhaust gas from the incinerator).
To Next Page
Loading...