GREENLINE 40 - Page 133

Greenline 40 126
Over speed
el. prop.
mode
0x2000 30
Neutral mode /
El. prop. interrupted
Rotational speed in electric
propulsion above max level
Wait for electric
motor speed-drop
3
/ 0x4000 31
Bad temp.
sensors
0x8000 32 Warning
After power-up detected HCU,
motor or battery temperature
out of normal limits
Check temperature
sensors
Note 1: Error decimal code number 1 can sometimes occur in starter mode if electric motor is heavily loaded.
Note 2: Exact limit value depends on the current HCU operating mode.
Note 3: Exact limit value depends on chosen speed setting of the electric propulsion mode.