(Revised 1/02)
TROUBLESHOOTING
7-24
PROBLEM: FAN MOTOR DOES NOT OPERATE - (Continued)
Probable Cause
Corrective Action
Relay board or control panel problem.
Motor may be defective.
Perform relay board power supply check.
See page 8-3.
Replace motor. See the “Maintenance” section (page 8-
41) for motor repair instructions.
PROBLEM: MEAT PROBE ERROR
Probable Cause
Corrective Action
Temperature display window reads “PrOb
OUT”
Connect the meat probe by plugging it into its socket.
T
urn the oven to the Oven Mode and Set the temperature
to 200°. Now set the probe temperature to 200°. The
temperature display window will show the actual meat
probe temperature.
PROBLEM: MOTOR VIBRATES EXCESSIVELY
Probable Cause
Corrective Action
Food on fan blades.
Fan damaged.
Loose mounting hardware.
Loose or missing motor housing nuts.
Motor bearings bad.
WARNING
Be sure oven is disconnected from branch
circuit power before performing any repair
work.
Clean fan blades.
Replace fan. See page 8-41.
Tighten motor mounting hardware.
Tighten and/or install missing nuts.
Replace motor
. See page 8-41.
To Next Page
Loading...
