Automatic Greasing System OnePlus
Installation
25
Date of issue: October 2011
EG1605R01
4Installation
4.1 Overview
To install a
Groeneveld
OnePlus greasing system the following tasks must be per-
formed:
1. Mounting the pump (including the control unit).
2. Mounting the progressive distribution blocks.
3. Mounting the primary grease line in between the pump and the (main) distri-
bution block and when applied in between the main distribution block and
the secondary distribution blocks.
4. Mounting the secondary grease lines and couplings.
5. Mounting the electrical wiring.
6. Testing the system.
4.2 Safety precautions
1. Take the necessary precautions to prevent potentially dangerous situations
from occuring during installation, checking and maintenance.
2. Always apply or use adequate safety measures to prevent bodily harm and
damage, before you start working on the vehicle.
3. Ensure the vehicle is immobilised before you start work. Remove the ignition
key and store it in a safe place. Block parts that may move on their own
accord. Engage the parking brake.
4. Pay special attention to tailbords, loading flaps, drop flaps, etc. Take care that
you can work safely unter these parts, without these parts can drop down.
5. Never work underneath a vehicle which is raised by a jack only. Always use a
trestle and check that the ground is firm and flat enough.
6. Keep in mind that a vehicle with air-suspension may drop of its own accord.
7. Only work underneath the cabin if it is fully tilted (and latched). Otherwise a
support must be placed underneath the cabin to ensure the cabin cannot
drop back.
8. Disconnect the earth-clamp from the vehicle’s battery. This prevents electrical
equipment from being inadvertently activated.
9. Avoid working on the cooling system without allowing it to cool down first.
The system is pressurised and may cause burns. Direct contact with the (poi-
sonous ) cooling fluid must be avoided.
10. Adhere to all regulations, specifications and limitations as specified by the
manufacturer of the machine, vehicle or engine.
11. Only use tools that fit and are designed for the specific task you want to per-
form with them.
12. A vehicle or machine may only be operated by those who are competent to
do so and aware of all possible dangers. If necessary, an expert should be con-
sulted.
13. Keep the environment in which you work clean and tidy. This enhances safety.
To Next Page
Loading...
