General information6
Date of issue: October 2011
Automatic Greasing System OnePlus
EG1605R01
1 General information
1.1 Introduction
With an automatic greasing system of
Groeneveld
all grease points of a vehicle or
machine are lubricated automatically at the correct moment and with the correct
amount of grease. Because greasing takes places while the vehicle or machine is in
operation, the applied grease is spread optimally over the whole surface to be
greased. The greasing system requires no user intervention to operate, apart from
periodically replacing the grease in its reservoir.
Groeneveld’s
automatic greasing systems are designed with the utmost care and
tested rigorously. This guarantees an extended operational life and error-free
operation, even under the most extreme operating conditions.
Proper installation, using the correct type of grease, and periodic checks are
prerequisites for the continual hassle-free operation of the system. The periodic
checks, which take little time and effort, can be performed during the normal
maintenance of the vehicle or machine (during oil-replacement, for instance).
Careful selection of construction materials, makes the greasing system itself vitually
maintenance-free.
ATTENTION
The automatic greasing system reduces the time and effort spent on
manual greasing significantly. However, do not forget that there may be
grease points that are
not
served by the greasing system and must still be
greased by hand.
1.2 The OnePlus automatic greasing system
A
Groeneveld
OnePlus automatic greasing system serves each grease point of the
vehicle, machine or installation in sequence, i.e. grease is supplied to the connected
grease points one at a time and one after the other (it is a progressive greasing
system).
OnePlus systems are mainly applied on machines with a fixed number of grease
points that require fixed amounts of grease at fixed intervals. This, because the
amount of grease that will be supplied to the individual grease points is governed
by the distribution ratios that results from the choice of doser segment types and
the manner in which those segments are combined in distribution blocks.
To Next Page
Loading...
