Maintenance36
Date of issue: October 2011
Automatic Greasing System OnePlus
EG1605R01
5 Maintenance
5.1 General
The maintenance of
Groeneveld’s
OnePlus systems can be combined with the nor-
mal maintenance of the vehicle or machine.
WARNING:
If a high-pressure steam/water jet is used to clean the vehicle or machine,
the pump unit of the greasing system should not be directly exposed to the
jet. This to prevent water from entering the pump unit through its de-aer-
ating opening. During normal operation, however, water will never be able
to enter the pump unit.
ATTENTION:
The automatic greasing system reduces the time and effort spent on
manual greasing significantly. However, do not forget that there may be
grease points that are not served by the greasing system and must still be
greased by hand.
5.2 Regularly checks of the greasing system
Check the following points of the OnePlus greasing system:
1. The grease level in the reservoir of the pump unit (refill on time).
2. The pump unit for damage and leakage.
3. The primary and secondary grease lines for damage and leakage.
4. The grease points, collar of fresh grease should be present at all grease
points.
5. Retrieve a possible fault code of a pending error(s), stored the last performed
automatic greasing cycle, by depressing the test push button for at least 5 sec-
onds and watch the indicator lamp 7 seconds after (only possible when the
optional indicator lamp is mounted).
6. Perform a test cycle and check the correct function (hold the test push button
depressed in between 3 and 5 seconds).
To Next Page
Loading...
